Section 5 – Maintenance Procedures Page 5 - 23 CFP83 Series Procedure 24 Change Fuel Filter (Spin-on Type) WARNING Fuel is flammable. Keep all cigarettes, flames, pilot lights, arcing equipment, and switches out of the work area and areas sharing ventilation to reduce the possibility of severe personal injury or death when working on the fuel system. CAUTION Use caution when disconnecting or removing fuel lines, replacing filters and priming the fuel system that fuel is not spilled or drained into the bilge area. Do not drop or throw filter elements into the bilge area. The fuel and fuel filters must be discarded in accordance with local environmental regulations.
CAUTION Mechanical overtightening can distort the threads as well as damage the filter element seal or filter canister. Remove NOTE : Close any OEM fuel valves (if equipped) to prevent fuel from draining or siphoning. Clean the area around the fuel filter head. Remove the filters. Clean the gasket surface of the filter head. Replace the o-ring. Install Fill the new filter(s) with clean fuel, and lubricate the o-ring seal with clean lubricating oil. Fuel-water separator - used in single-filter applications. Drawing No. 9777, Section 5, Rev. 02-07