Page 5 - 24 Section 5 – Maintenance Procedures CFP83 Series It will be necessary to fill the 10-micron water stripping (suction side) fuel filter with fuel. Do not fill the 10-micron (pressure side) fuel filter with fuel before installation; instead, prime the fuel system using the fuel lift pump. Be sure the center seal ring is installed onto the filter spud. CAUTION Mechanical over-tightening will distort the threads, filter element seal or filter can. Install the filter as specified by the filter manufacturer. Prime WARNING Do not open the high-pressure fuel system with the engine running. Engine operation causes high fuel pressure.
High-pressure fuel spray can cause serious injury or death. Open the fuel supply and return valves, if equipped. Finishing Steps Once the engine is started, slowly increase the engine speed while air is purged from the fuel plumbing. Drawing No. 9777, Section 5, Rev. 02-07