Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 5 – Maintenance Procedures Page 5 - 31 CFP83 Series WARNING Before removing the pressure cap, wait until the coolant temperature is below 50°C [120°F]. Failure to do so can cause personal injury from heated coolant spray. Install the pressure cap (Cummins Fire Power Part No 11407.). Operate the engine until it reaches a temperature of 82°C [180°F], and check for coolant leaks. Check the coolant level again to make sure the system is full of coolant, or that the coolant level has risen to the hot level in the recovery bottle on the system, if so equipped.

Procedure 28 Change Coolant Filter Remove WARNING Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap (Cummins Fire Power Part No. 11407). Remove the coolant system pressure cap and close the shutoff valve before removing the coolant filter. Failure to do so can result in personal injury from heated coolant spray. Remove the coolant system pressure cap (Cummins Fire Power Part No. 11407). Turn the shutoff valve to the OFF position by rotating the knob from vertical to horizontal in the direction shown. Drawing No. 9777, Section 5, Rev. 02-07