Section 5 – Maintenance Procedures Page 5 - 33 CFP83 Series Install CAUTION Do not allow oil to get into the filter. Oil will damage the DCA. CAUTION Mechanical over-tightening can distort the threads or damage the filter head. Apply a thin film of lubricating oil to the gasket sealing surface before installing the new coolant filter. Install the coolant filter on the filter head. Tighten the filter until the gasket contacts the filter head surface. Tighten the coolant filter an additional 1/2 to 3/4 of a turn, or as specified by the filter manufacturer. CAUTION The valve must be in the ON position to prevent engine damage.
Turn the shutoff to the ON position by rotating the knob from horizontal to vertical in the direction shown. Test Run Install the coolant system pressure cap, (Cummins Fire Power Part No. 11407). Operate the engine. Check for coolant leaks. After the air has been purged from the system, check the coolant level again. Drawing No. 9777, Section 5, Rev. 02-07