Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 5 - 34 Section 5 – Maintenance Procedures CFP83 Series Procedure 29 Vent Fuel Supply Lines Controlled venting is provided at the injection pump through the fuel drain manifold. Small amounts of air introduced by changing the filters or injection pump supply line will be vented automatically if the fuel filter is changed in accordance with the instructions. No manual bleeding of fuel lines is required. General Information NOTE : Manual bleeding is required if any of the following is true: The fuel filter is not filled prior to installation. The injection pump is replaced. High-pressure fuel line connections are loosened or lines replaced.

Engine is initially started or started after an extended period of no engine operation. Low Pressure Fuel Line(s) Open the vent screw. Allow fuel to drain until the fuel flowing from the fitting is free of air. Tighten the vent screw. Torque value: 8 N•m (6ft-lb) The low pressure fuel lines are bled by pumping the hand lever on the filter head. High Pressure Fuel Line(s) WARNING The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious bodily harm. Venting is accomplished by loosening one or more fittings at the injectors and cranking the engine to allow entrapped air to bleed from the lines. Drawing No. 9777, Section 5, Rev. 02-07