Section 5 – Maintenance Procedures Page 5 - 35 CFP83 Series WARNING Do not bleed a hot engine as this could cause fuel to spill onto a hot exhaust manifold creating a danger of fire. With the engine at idle, vent one line at the time until the engine runs smoothly. Retighten Line Fittings Tighten the line fittings and check for leaks. Torque Value: 22 N•m [16 ft-lb] Procedure 30 Vent Injection Pump WARNING The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious personal injury. Wear gloves and protective clothing. Loosen the fittings at the injectors, and crank the engine to allow entrapped air to bleed from the lines. Tighten the fittings.
WARNING It is necessary to put the engine in the run position. Because the engine could start, be sure to follow all the safety precautions. Use the normal engine starting procedure. Start the engine and vent one line at a time until the engine runs smoothly. NOTE : Do not engage the starter for more than 30 seconds each time when it is used to vent the system: Wait 2 minutes between engagements. Drawing No. 9777, Section 5, Rev. 02-07