Section 5 – Maintenance Procedures Page 5 - 37 CFP83 Series Remove the drive belt. Poly-Vee Belt Visually inspect the belt. Check the belt for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. Belt damage can be caused by: Incorrect tension Incorrect size or length Pulley misalignment Incorrect installation Severe operating environment Oil or grease on the belts Drawing No. 9777, Section 5, Rev. 02-07