Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 5 – Maintenance Procedures Page 5 - 39 CFP83 Series Check the tensioner bearing. The tensioner pulley should spin freely with no rough spots detected under hand pressure. Replace tensioner or bearing if defective. Install the drive belt. Torque Value: Tension Limit: 360 to 490 N•m [266 to 361 ft-lb] Check the location of the drive belt on the belt tensioner pulley. The belt should be centered on, or centered close to the middle of, the pulley. Unaligned belts, either too far forward or backward, can cause belt wear, belt roll-off failures, or increase uneven tensioner bushing wear. Drawing No. 9777, Section 5, Rev. 02-07