Section 5 – Maintenance Procedures Page 5 - 49 CFP83 Series Every Four Years or 5000 Hours General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Procedure 38 Inspect Overhead Set Preparatory Steps Remove the crankcase breather tube, rocker lever cover mounted breather only. Remove the variable geometry turbocharger actuator air supply line, if equipped. Remove the capscrews. Remove the rocker lever cover and gasket. NOTE : Rocker lever cover configurations will be different based upon if the cover is center bolted or perimeter bolted.
Remove the plastic fuel pump drive cover located on the front of the engine. Drawing No. 9777, Section 5, Rev. 02-07