Page 5 - 50 Section 5 – Maintenance Procedures CFP83 Series Adjust CAUTION Engine coolant temperature should be less than 60°C [140°F]. Use the barring tool, Part Number 3824591, or equivalent, and rotate the crankshaft to align the top dead center marks on the gear cover and the fuel pump gear. With the engine in this position, lash can be checked on the following rocker arms: 1l, 1E, 2l, 3E, 4l, and 5E. Lash Check Limits mm in Intake 0.152 MIN 0.006 0.559 MAX 0.022 Exhaust 0.381 MIN 0.015 0.813 MAX 0.032 NOTE : Lash checks are performed as part of a troubleshooting procedure, and resetting is not required during checks as long as the lash measurements are within the above limits .
Drawing No. 9777, Section 5, Rev. 02-07