Section 5 – Maintenance Procedures Page 5 - 51 CFP83 Series Measure lash by inserting a feeler gauge between the crosshead and the rocker lever ball insert and socket while lifting up on the end of the rocker arm. If the lash measurement is out of specification, loosen the locknut and adjust the lash to the nominal specification. Lash Reset Specifications mm in Intake 0.305 NOM 0.012 Exhaust 0.559 NOM 0.022 NOTE: Lash resets are only required at the interval specified in the Maintenance Schedule, when lash is measured and found out of specification, or when engine repairs cause removal of the rocker arms and/or loosening of the adjusting screws. Tighten the locknut and measure again.
Torque Value: 24 N•m [18 ft-lb] Use the barring tool, Part Number 3824591, or equivalent, and rotate the crankshaft 360 degrees and measure lash for rocker arms 2E, 3l, 4E, 5l, 6l, and 6E. Reset the lash, if out of specification. Drawing No. 9777, Section 5, Rev. 02-07