Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 5 - 52 Section 5 – Maintenance Procedures CFP83 Series Finishing Steps Center Bolted Rocket Lever Cover Place the gasket on the cylinder head. Be sure the gasket is properly aligned around the cylinder head capscrews. Install the rocker lever cover and capscrews. Tighten the capscrews. Torque Value: 12 N•m [106 in-lb] NOTE : If the gasket has been removed from the rocker lever cover, a new gasket must be used. Perimeter Bolted Rocker Lever Cover The following installation procedure must be used when installing the press-in gasket: 1. Press the molded gasket into the corners of the rocker lever cover. 2. Press the gasket around the capscrew mounting holes. 3.

Press the remaining gasket into the rocker lever cover. Drawing No. 9777, Section 5, Rev. 02-07