Section 7 – Adjustment, Repair, and Replacement Page 7-7 CFP83 Series Belt Guard Removal/Installation Prepare WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap (Cummins Fire Power Part No.11407). Heated coolant spray or steam can cause personal injury. Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. Disconnect or isolate the coolant heater power supply.
REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries! Next, disconnect both batteries at their terminals. Drawing No. 9777, Section 7, Rev. 02-07