Page 7-12 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Belt Removal/Installation Prepare Do the preparatory steps and remove the Belt Guard. Refer to Belt Guard Removal / Installation in this section. Remove NOTE : The belt tensioner is spring-loaded and must be pivoted away from the drive belt. Pivoting in the wrong direction can result in damage to the belt tensioner. Lift belt tensioner to relieve tension in the belt, and remove the belt. Install Service Tip :
If difficulty is experienced installing the drive belt; for example, the belt seems too short; position the belt over the grooved pulleys first; then, while holding the tensioner up, slide the belt over the water pump pulley. NOTE : The belt tensioner is spring-loaded and must be pivoted away from the drive belt. Pivoting in the wrong direction can result in damage to the belt tensioner. NOTE : Install only Cummins approved replacement v-ribbed belts (Cummins Part No. 3288812) or equivalent. Lift belt tensioner to relieve tension in the belt, and install the belt. Allow the belt tensioner to relax.
Ensure that the belt tensioner supplies tension to the belt without being at a mechanical limit stop. Follow-Up When work is completed, install the Belt Guard and do the listed follow up steps. Refer to Belt Guard Removal/Installation in this section. Check that the drive belt operates without unusual noises. Drawing No. 9777, Section 7, Rev. 02-07