Page 7-20 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Heat Exchanger Removal/Installation (Cont) Install Provide support for the coolant heat exchanger in order to avoid dropping it. Position the heat exchanger and clamps on the engine’s mounting bracket and start the four bolts. Start the nut and washers on the four bolts. Align the heat exchanger with the required hose connections and tighten the four back sets of clamp fasteners. Tighten the two front sets of clamp fasteners. Torque Value: As per capscrew markings and torque values in Section 10 Follow-Up Install the Upper Engine Coolant Hose at the heat exchanger.
Install the Lower Engine Coolant and Fill Hose at the heat exchanger. Install the Coolant Vent Hose at the heat exchanger. CFP83-F10, F20, or F30 Only NOTE : If using piping supplied by Cummins Fire Power, refer to Drawing 9637 in Section 13 for raw water supply piping details. Install the 1” NPT raw water inlet piping from the valve manifold to the heat exchanger. Also, install any customer-supplied raw water outlet fittings. Drawing No. 9777, Section 7, Rev. 02-07