Page 7-34 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Hose Removal/Installation (Cont) Install the Lower Engine Coolant and Fill Hoses CAUTION Do not re-install worn or damaged hoses or corroded clamps. NOTE : Refer to Assembly Drawing 8919 in Section 13 for detailed construction. Position the hose clamps on the hose. Position the hoses at the connections on the heat exchanger and engine. Position and tighten the hose clamp at the engine. Position and tighten the lower hose clamp at the heat exchanger. Position and tighten the fill hose clamp at the heat exchanger. Torque Value:
As per capscrew markings and torque values in Section 10 Install the nuts and U-bolt supporting the lower hose. Tighten as per Capscrew Markings and Torque Values in Section 10. Install the Upper Coolant Heater Hose NOTE : Refer to Assembly Drawing 8930 in Section 13 for detailed construction. Position the hose clamps on the hose. Push the hose on the fitting at the heater and at the engine connection. Position and tighten the hose clamps. Torque Values: As per capscrew markings and torque values in Section 10 Drawing No. 9777, Section 7, Rev. 02-07