Page 7-36 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Hose Removal/Installation (Cont) All Close the coolant drain valve. Refill engine coolant as required Refer to Drain and Flush Coolant System in Section 5. Install the coolant system pressure cap (Cummins Fire Power Part No. 11407). Reconnect the coolant heater power supply. For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed. NOTE : Start the engine and do a quick check for leaks.
If any coolant leaks are observed, stop the engine, repair the leak, check coolant level, then restart the engine. Start the engine. Refer to Normal Local Starting Procedure in Section 3. Check for and repair any coolant leaks. Drawing No. 9777, Section 7, Rev. 02-07