Section 7 – Adjustment, Repair, and Replacement Page 7-47 CFP83 Series Coolant Temperature Sender Removal/Installation Prepare WARNING Coolant is toxic. Keep away from pets and children. If not reused, dispose of in accordance with local environmental regulations. WARNING Do not remove the pressure cap from a hot engine. Wait until the temperature is below 50°C [122°F] before removing the pressure cap, (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. Drain the coolant. Refer to Drain and Flush Cooling System in Section 5. Remove Disconnect the temperature sensor wiring. Remove the temperature sensor. Install NOTE :
Apply liquid teflon sealant to the threads when installing the temperature sensor. Install the temperature sensor. Torque Value: (Cast Iron) 50 N•m [37 ft-lb] Reconnect the wiring. (Aluminum) 30 N•m [22 ft-lb] Drawing No. 9777, Section 7, Rev. 02-07