Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-51 CFP83 Series Coolant Thermostat Removal/Installation Prepare WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. CAUTION Always use the correct thermostat, and never operate the engine without a thermostat installed.

The engine can overheat if operated without a thermostat because the path of least resistance for the coolant is through the bypass to the pump inlet. An incorrect thermostat can cause the engine to overheat or run too cold. Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. Disconnect the battery cables at the battery source. Drain the coolant. Refer to Drain and Flush Cooling System in Section 5. Disconnect the upper engine coolant hose. Refer to Coolant Hose Removal/Installation in this section. Drawing No. 9777, Section 7, Rev. 02-07