Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-58 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Thermostat Tests (Cont) Start the engine. Refer to Local Starting Procedure for Testing in Section 3. Operate the engine for one minute and then stop it. Measure the amount of coolant collected in the container. The amount of coolant collected must not be more than 150 cc [5 fl oz]. If more than 150 cc [5 fl oz] of coolant is collected, the thermostat is leaking and must be replaced. Refer to Coolant Thermostat Removal/Installation in this section. If leakage is not present, then continue to perform the Coolant Thermostat Function Test below. Coolant Thermostat Function Test Start the engine.

Refer to Local Starting Procedure for Testing in Section 3. Allow the engine to approach operating temperature. Monitor the operation of the thermostat. Thermostat Initial Opening Temperature MIN: 81 o C [178 o F] MAX: 83 o C [181 o F] If the coolant does not start flowing into the container during the initial opening temperature range, the thermostat must be replaced. Refer to Coolant Thermostat Removal/Installation in this section. Stop the engine when the coolant starts to flow. Install the heat exchanger hose and tighten hose clamp. If used, remove the temperature sensor and reinstall the pipe plug. Return any coolant to the engine. Drawing No. 9777, Section 7, Rev. 02-07