Section 7 – Adjustment, Repair, and Replacement Page 7-57 CFP83 Series Coolant Thermostat Tests Coolant Thermostat Leak Test CAUTION The engine thermostat must operate properly in order for the engine to operate in the most efficient heat range. Overheating or overcooling will shorten engine life. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. Allow the engine to cool well below 83 o C [181 o F]. Loosen the hose clamp on the Upper Engine Coolant Hose. Remove the hose from the thermostat housing.
Install a hose of the same size on the thermostat housing outlet long enough to reach a remote, dry container used to collect coolant. Install and tighten a hose clamp on the housing outlet. Place the other end of the hose in a dry container. If desired, install an accurate thermocouple or temperature gauge in the ѕ-inch pipe plug located at the front of the cylinder block. Otherwise, monitor the engine coolant temperature on the local control panel. Drawing No. 9777, Section 7, Rev. 02-07