Section 7– Adjustment, Repair, and Replacement Page 7-93 CFP83 Series Crank Solenoid Assembly Removal/Installation (Cont) Drawing No. 9777, Section 7, 02-07 Demonstrate Local Electrical Start NOTE: If Crank Solenoid A was replaced, start the engine using CRANK BATT A. Alternatively; use B if B was replaced. Start the engine electrically from the local control panel. Refer to Normal Local Starting Procedure in Section 3. Verify that the engine starts normally with no unusual indications. Stop the engine. Demonstrate Local Manual Start NOTE: If Crank Solenoid A was replaced, start the engine using CRANK BATT A. Alternatively; use B if B was replaced.
Start the engine manually from the crank solenoid lever handle. Refer to Normal Local Starting Procedure in Section 3. Verify that the engine starts normally with no unusual indications. Stop the engine. Place the AUTO/MANUAL rocker switch in the AUTO position. Return the fire protection system to operating status.