Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-92 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Crank Solenoid Assembly Removal/Installation (Cont) Install NOTE : Install the correct component. For 12 VDC systems, use Cummins NPower Part No 8824. For 24 VDC systems, use Cummins NPower Part No 8846. Position the four bolts through the mounting holes. Position the crank solenoid on the bolts, add the lock washers, and start the nuts. Tighten the four mounting nuts. NOTE : Refer to Drawing 10423 Sheet 1 in Section 13 for crank solenoid schematic information. Position the flat washers, cable lugs, lock washers, and nuts on the studs in the same order as was removed. Tighten the nuts on the studs. Torque Values:

As per capscrew markings and torque values in Section 10 With power still disconnected, verify that the lever handle on the crank solenoid operates freely. Follow-Up NOTE : Refer to Battery Removal/Installation in this section for detailed instructions for reconnecting the battery cable clamps. Connect the negative battery cable from Battery A. Connect the negative battery cable from Battery B. Drawing No. 9777, Section 7, Rev. 02-07