Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7– Adjustment, Repair, and Replacement Page 7-91 CFP83 Series Crank Solenoid Assembly Removal/Installation NOTE : Use this procedure to remove and install either or both of the crank solenoid assemblies. The crank solenoid assembly sub-components are not serviceable parts as supplied by Cummins Fire Power. Drawing No. 9777, Section 7, 02-07 Prepare Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. NOTE: Refer to Battery Removal/Installation in this section for detailed instructions for disconnecting the battery cable clamps. Disconnect the negative battery cable from Battery A.

Disconnect the negative battery cable from Battery B. Remove NOTE: Refer to Drawing 10423 Sheet 1 in Section 13 for schematic information related to the crank solenoid assemblies. NOTE: Ensure that the wires are clearly identified for ease of reconnection. NOTE: Observe the location of flat and lock washers for ease of reconnection. NOTE: Save the nuts, bolts, flat washers, and lock washers for reuse. Disconnect all electrical connectors from the solenoid’s four terminal studs. Loosen the four sets of mounting nuts, bolts, and washers. Remove the crank solenoid and fasteners from the engine.