Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-90 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Starter Motor Assembly Removal/Installation (Cont) Remove the starting motor. Install NOTE : Use only the Delco 39MT replacement starter Cummings Part No. ST9370 / 3971603 (12 VDC) or Cummings Part No. ST9258 / 3957598 (24 VDC). Align and install the starter motor. Install and tighten the three mounting capscrews. Torque Value: 43 N•m [32 ft-lb] Start the engine. Refer to Normal Local Starting Procedure in Section 3. Observe that the engine starts with no unusual noises or vibrations. Stop the engine. Drawing No. 9777, Section 7, Rev.

02-07 For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed. Place the AUTO/MANUAL rocker switch in the AUTO position. Return the fire protection system to operating status.