Section 7– Adjustment, Repair, and Replacement Page 7-95 CFP83 Series Control Panel Fuse Replacement (Cont) Drawing No. 9777, Section 7, 02-07 NOTE: The fuses are ATO/ATC ¼” blade type automotive fuses. The 20 Amp fuses (Fuse 1, 2, and 3) are colored yellow. The five amp fuse is colored tan. NOTE: Refer to Drawing 10423 Sheet 1 in Section 13 for schematic details. NOTE: The fuses are ordered from top to bottom as follows: 5 A Fuse F4 (Control Panel Indications) 20 A Fuse F1 (Battery A) 20 A Fuse F2 (Battery B) 20 A Fuse F3 (Crank Circuit) Select the fuse for testing or replacement. Pull the fuse from the fuse block. Check for continuity either visually or with an ohmmeter.
Check for short circuits to ground on any fuse circuit that had an open circuited fuse. Correct any faults. If necessary, remove, test, or replace the engine harness. Refer to Engine Harness Removal/Installation in this section. Install Replace any fuse with an open circuit. Place the new fuse into the fuse block and press it in until the fuse is properly inserted. Install the fuse block cover and tighten the cover screw, Close the control panel. For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries!
Reconnect the batteries at their terminals after all service work has been completed.