Page 7-96 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Control Panel Fuse Replacement (Cont) Drawing No. 9777, Section 7, Rev. 02-07 NOTE: If Fuse 1 or Fuse 2 was replaced, start the engine using CRANK BATT A or CRANK BATT B respectively. Start the engine. Refer to Normal Local Starting Procedure in Section 3. Observe that the engine starts with no unusual indications. Observe that engine speed is indicated. Observe that raw water flow has started. Stop the engine. Place the AUTO/MANUAL rocker switch in the AUTO position. Return the fire protection system to operating status.