Section 7 – Adjustment, Repair, and Replacement Page 7-101 CFP83 Series Exhaust Shield Removal/Installation (Cont) Install Install the exhaust shield and fasteners. Refer to Drawing 8913 (for CFP83-F10, F20, F30 models) or Drawing 8937 (for CFP83-F40 model) in Section 13. Torque Value: As per capscrew markings and torque values in Section 5 For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed.
If functional components were removed, repaired, or replaced, perform the appropriate installation checks and engine starts as listed in Section 3. Verify that the components operate properly. If testing is completed, place the AUTO/MANUAL rocker switch in the AUTO position. Drawing No. 9777, Section 7, Rev. 02-07