Page 7-100 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Exhaust Shield Removal/Installation Prepare Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries! Next, disconnect both batteries at their terminals.
Remove Remove the exhaust shield and fasteners. Refer to Drawing 8913 (for CFP83-F10, F20, F30 models) or Drawing 8937 (for CFP83-F40 model) in Section 13. Drawing No. 9777, Section 7, Rev. 02-07