Section 7 – Adjustment, Repair, and Replacement Page 7-107 CFP83 Series Inline Fuel Injection Pump Removal/Installation (Cont) Reverse the position of the pin so the slot of the pin will fit over the timing tooth in the pump. Install and secure the pin with the access plug. CAUTION The fuel pump drive inside diameter and the shaft outside diameter must be clean and dry before installing the shaft into the gear. A non-petroleum-based cleaner can be used to clean the drive gear and shaft mounting surfaces. Failure to do so will result in gear slippage in the retarded direction. Clean the drive gear and shaft with a non- petroleum-based cleaner. NOTE :
If the mounting flange o-ring has a colored stripe, it can not be reused. Replace with a new o-ring. Furthermore, do not lubricate the new-type o-ring. Instead, lubricate the seating area of the gear housing. Lubricate the mounting flange of the fuel injection pump with clean lubricating engine oil. NOTE : The P7100 fuel injection pump driveshaft has a provision for a Woodruff key; however, it is not required for the P7100 drive gear. Drawing No. 9777, Section 7, Rev. 02-07