Page 7-108 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Inline Fuel Injection Pump Removal/Installation (Cont) Slide the pump shaft through the drive gear, and position the pump flange onto the mounting studs. Push the pump forward until the mounting flange and o-ring are properly fitted into the gear housing bore. If equipped, finger-tighten the capscrews for the support bracket. Tighten the mounting nuts. Torque Value: Mounting Nuts 44 N•m [32 ft-lb] Tighten the capscrews for the rear support bracket. Torque Value: Support Bracket 14 N•m [124 in-lb] Install the fuel injection pump retaining nut and washer. Torque Value: 10 to 15 N•m [89 to 133 in-lb] Drawing No.
9777, Section 7, Rev. 02-07