Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-142 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Fuel Injectors Removal/Installation (Cont) Follow-Up Reconnect the high-pressure fuel lines. Refer to High Pressure Injector Supply Lines Removal/Installation in this section. Reconnect the fuel drain manifold. Refer to Fuel Drain Manifold Removal/Installation in this section. Operate the engine. Check for leaks. Check function. Stop the engine. RTN Drawing No. 9777, Section 7, Rev. 02-07 CAUTION Be careful not to damage the tip of the injector when installing. NOTE: When installing the injector, clean around the injector, and do not allow dust or dirt to enter the engine. NOTE:

If there is no abnormality in the injector, install it in the same position during assembly. Install the injector, washer, and mounting capscrew. Tighten the capscrew. Torque Value: 44 N•m [33 ft-lb]