Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-141 CFP83 Series Fuel Injectors Removal/Installation Prepare Clean around the injectors. Disconnect the high-pressure fuel lines. Refer to High Pressure Injector Supply Lines Removal/Installation in this section. Disconnect the fuel drain manifold. Refer to Fuel Drain Manifold Removal/Installation in this section. Remove CAUTION Be careful not to damage the tip of the injector when removing. Remove the mounting capscrew, washer, and injector. NOTE : When removing the injector, clean around the injector, and insert a blind plug to prevent dust or dirt from entering the engine. NOTE :

Mark the injectors with tags showing the cylinder number, and keep it in a safe place. If there is no abnormality in the injector, install it in the same position during assembly. Install NOTE : Install new injector gasket (Cummins Part No. C6204113880) or replacement injector kit (Cummins Option No. II3002.01). Coat the injectors with anti-seize compound, Part No. 3824879, before installation. Drawing No. 9777, Section 7, Rev. 02-07