Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-149 CFP83 Series Air Leaks, Air Intake and Exhaust Systems Checks Prepare Initial Check CAUTION Engine intake air must be filtered to prevent dirt and debris from entering the engine. If intake air piping is damaged or loose, unfiltered air will enter the engine and cause premature wear. Inspect the intake air piping for cracked hoses, damage, or loose clamps. Replace damaged pipes, and tighten loose clamps, as necessary, to make sure the air intake system does not leak. Torque Value: 8 N•m [71 in-lb] Check for corrosion of the intake system piping under the clamps and hoses.

Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean, as required. Operate the engine at high idle, and use a solution of soapy water to spot intake air leaks. If an air leak exists, the soap bubbles will be drawn in with the air. Drawing No. 9777, Section 7, Rev. 02-07