Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-165 CFP83 Series Charge Air Cooler (CAC) Removal and Installation (for CFP83-F40 only) If the engine experiences a turbocharger failure or any other occasion where oil or debris is put into the charge air cooler, the charge air cooler must be cleaned or replaced. Remove charge air cooler from the engine. Install Install two clamps on the cooler assembly Install the cooler assembly and start the bolts on the mounting bracket. NOTE : Apply Teflon tape or pipe sealant to the threaded fittings as the raw water piping is reinstalled. Re-connect the CAC Raw Water Coolant Outlet Piping Assembly to the CAC.

Re-connect the CAC Raw Water Coolant Inlet Piping Assembly to the CAC. Connect the CAC Air Outlet Piping Assembly to the CAC. Connect the CAC Air Inlet Piping Assembly to the CAC. Drawing No. 9777, Section 7, Rev. 02-07 Remove Refer to Assembly Drawing 8967 and 10903 in Section 13. Disconnect the CAC Air Outlet Piping Assembly from the CAC. Disconnect the CAC Air Inlet Piping Assembly from the CAC. Disconnect the CAC Raw Water Coolant Inlet Piping Assembly from the CAC. Disconnect the CAC Raw Water Outlet Piping Assembly from the CAC. Remove the bolts from mounting bracket and remove the cooler assembly. Remove the two clamps from the cooler assembly.