Page 7-178 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Turbocharger Radial Bearing Clearance (Cont) If oil is present only in the discharge side, install the air intake and charge air cooler piping. Refer to the OEM service manual. Check for intake restriction. Refer to Procedure 010-031. If excessive intake restriction is not found, replace the turbocharger. NOTE: If the engine experiences a turbocharger failure or any other occasion where oil is put into the charge air system, the charge air system must be inspected and cleaned. Refer to Procedure 010-027. Follow-Up Drawing No. 9777, Section 7, Rev. 02-07