Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-177 CFP83 Series Turbocharger Radial Bearing Clearance Prepare Radial Clearance Check Use a wire-type feeler gauge to measure the clearance between the compressor wheel and housing. Gently push the compressor wheel toward the compressor housing and gauge. Record the clearance. With the feeler gauge in the same location, gently push the compressor wheel away from the compressor housing and measure the clearance between the compressor wheel and housing. Subtract the smaller clearance from the larger clearance. This is the radial bearing clearance.

Radial Bearing Clearance Minimum 0.30 mm [0.012 in] Maximum 0.46 mm [0.018 in] Repeat the procedure on the turbine wheel. Replace the turbocharger if the radial bearing clearance does not meet specifications. See the Remove and Install steps in this procedure. Inspect the turbocharger compressor intake and discharge for oil. If oil is present in the compressor intake as well as in the discharge, check upstream in the turbocharger for the source of oil. Drawing No. 9777, Section 7, Rev. 02-07