Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-180 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Turbocharger Wastegate Actuator Removal and Installation (Cont) NOTE : Prior to removal, note position length of the control rod from the boost capsule housing and orientation of the boost capsule hose connector in relation to the mounting bracket. Remove the retaining clip from the control lever. Disconnect the integral boost line from the wastegate capsule. CAUTION Be careful not to bend the control lever. Disconnect the boost capsule actuator rod end from the turbocharger wastegate lever. This can be accomplished by slowly applying regulated air pressure to the boost capsule until the control rod is activated.

Disconnect the control rod from the turbocharger wastegate lever pin. NOTE : If the boost capsule diaphragm material is ruptured and will not hold air pressure, manually pull the control rod outward in order to overcome boost capsule spring tension for removal of the control rod from the turbocharger wastegate lever pin. Loosen the boost capsule mounting capscrews, disconnect the air supply hose, and remove assembly from the mounting bracket. Drawing No. 9777, Section 7, Rev. 02-07