Section 7 – Adjustment, Repair, and Replacement Page 7-183 CFP83 Series Turbocharger Wastegate Actuator Removal and Installation (Cont) Fit the actuator mounting studs into the holes in the bracket, and fit both actuator mounting capscrews. Refit the end-link onto the crank-pin. Install the control rod retaining clip. Torque Value: 8 N•m [75 in-lb] Tighten the control rod jam nut against the end- link. Cut the tie wrap and remove tie wrap and spacer piece. Discard tie wrap. Continue turning jam nut in the same direction, and tighten against end-link. Torque Value: 8 N•m [75 in-lb] Refit the air supply hose to the actuator using the new hose clamp provided. Follow-Up Drawing No.
9777, Section 7, Rev. 02-07