Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-182 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Turbocharger Wastegate Actuator Removal and Installation (Cont) Install NOTE: In some applications, the turbocharger must be removed in order to install a new wastegate actuator. Refer to Procedure 010- 033. Fit the end-link over the turbocharger wastegate lever pin. With the spine of the spacer visible and the turbocharger wastegate lever pushed toward the rod, lay the actuator alongside the mounting bracket. NOTE: Do not fit the two studs into the mounting holes at this time.

Adjust the length of the actuator assembly by removing from the turbocharger, rotating the end-link, and re-fitting the actuator until the underside of the actuator will just fit over the bracket mounting studs with less than 0.5-mm [0.20-in] gap. The setting is correct when the underside of the actuator will just fit over the bracket with less than 0.5-mm [0.20-in] gap. Drawing No. 9777, Section 7, Rev. 02-07