Page 7-200 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Lubricating Oil Pump Removal/Installation (Cont) Tighten in the sequence shown. Torque Value: 24 N•m [18 ft-lb] NOTE: The back plate on the pump seats against the bottom of the bore in the cylinder block. When the lubricating oil pump is correctly installed, the flange on the lubricating oil pump will not touch the cylinder block. NOTE: Be sure the gear backlash is correct if installing a new lubricating oil pump. Measure the gear backlash. Backlash Limits A MIN 0.75 mm [0.030 in] MAX 0.85 mm [0.033 in] B MIN 0.75 mm [0.030 in] NOTE:
If the adjoining gear moves when you measure the backlash, the reading will be incorrect. MAX 0.85 mm [0.033 in] Drawing No. 9777, Section 7, Rev. 02-07