Section 7 – Adjustment, Repair, and Replacement Page 7-201 CFP83 Series Lubricating Oil Pump Removal/Installation (Cont) Gear Cover - Installation Lubricate the front gear train with clean 15W-40 engine oil. CAUTION The seal lip and the sealing surface on the crankshaft must be free from all oil residue to prevent seal leaks. Thoroughly clean the front seal area of the crankshaft. NOTE: Always replace the front seal when removing and installing the gear cover. Refer to Procedure 001-023. Apply a thin bead of Three-Bond™, or equivalent, to the front cover side of the gasket only. NOTE: Do not remove the plastic seal pilot tool from the lubricating oil seal at this time.
Use the plastic seal pilot tool to guide the seal on the crankshaft. Install the gasket and front cover on the engine. Drawing No. 9777, Section 7, Rev. 02-07