Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-205 CFP83 Series Oil Pressure Gauge Removal/Installation Prepare Place the fire protection system in a safe mode r engine service. fo Place the AUTO/MANUAL rocker switch in the position. MANUAL REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. efore disconnecting the batteries, place the Firepump Controller in its appropriate service oid a “Battery Failure” B position in order to av alarm. Wear safety glasses when disconnecting batteries! Next, disconnect b terminals.

oth batteries at their Remove N TE: Refer to O Drawing 10423 Sheet 1 in ection 13 for electrical schematic details. S Open the local control panel. NOTE: Ensure that the wires for reconnection. are clearly tagged Loosen the nuts on the stud and remo wires. ve the Remove the nuts on the m remove the gauge from the panel. ounting bracket and Drawing No. 9777, Section 7, Rev. 02-07