Page 7-204 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Oil Pressure Sender Removal/Installation Prepare Remove Disconnect the wire from the sending unit. NOTE: The sending units illustrated can differ from those installed by the original equipment manufacturer (OEM). Inspect for Reuse Remove the OEM oil pressure sensor, and install a pressure gauge. Start the engine. Measure the lubricating oil pressure. Minimum lubricating oil pressure: Low Idle (675 to 725 rpm): 69 kPa [10 psi] High Idle rpm: 207 kPa [30 psi] Install Install the sending unit. Connect the wire to the sending unit. Torque Values:
Installed into Cast Iron 16 N•m [12 ft-lb] Installed into Aluminum 10 N•m [7 ft-lb ] Follow-Up Drawing No. 9777, Section 7, Rev. 02-07