Section 7 – Adjustment, Repair, and Replacement Page 7-209 CFP83 Series Speed Sensor or Mag Pick-Up Sensor Removal/Installation Prepare: Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries!
Next, disconnect both batteries at their terminals. Remove The Mag Pick-Up (Speed Sensor) which is mounted on the bell-housing and located over the flywheel teeth. Both the Speed Switch and the Tachometer (located in the Engine control Panel) use the Mag Pick-Up as the engine speed signal. The resistance on a good Mag Pick-Up should be approximately 265 Ohms. Remove the 2-wire cable that is connected to it. (The cable wires are not polarity sensitive, so it makes no difference how the wires are connected to it). Remove the Mag Pick-Up by turning it out counter-clockwise. Drawing No. 9777, Section 7, Rev. 02-07