Page 7-210 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Speed Sensor or Mag Pick-Up Sensor Removal/Installation (Cont) When installing a new Mag Pick-Up, first check that the threads in the bell-housing are clean. Any burrs may prevent proper installation. Install the Mag Pick-Up by threading it into the bell-housing until its tip is bottomed out against the flywheel. Then back out the Mag Pick-Up Ѕ turn. Reconnect the 2-wire cable. Reconnect the batteries. For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries!
Reconnect the batteries at their terminals after all service work has been completed. Place the AUTO/MANUAL rocker switch in the AUTO position on the fire pump panel. Return the fire protection system controller back to operating status. Drawing No. 9777, Section 7, Rev. 02-07