Section 7 – Adjustment, Repair, and Replacement Page 7-211 CFP83 Series Tachometer Removal/Installation Prepare: Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries! Next, disconnect both batteries at their terminals.
To remove the tachometer, open the cover of the Engine Control Panel. Disconnect the 3- wire connector that is plugged into the back of the tachometer. Next, remove the tachometer’s retaining bracket. Drawing No. 9777, Section 7, Rev. 02-07