Section 7 – Adjustment, Repair, and Replacement Page 7-213 CFP83 Series Overspeed Switch Removal/Installation Prepare: Place the fire protection system in a safe mode for engine service. Place the AUTO/MANUAL rocker switch in the MANUAL position. REMOVE BATTERY POWER BEFORE SERVICING ENGINE OR CONTROLS For safety reasons, both batteries must be disconnected before performing service on the Firepump Engine or on any of its controls. Before disconnecting the batteries, place the Firepump Controller in its appropriate service position in order to avoid a “Battery Failure” alarm. Wear safety glasses when disconnecting batteries! Next, disconnect both batteries at their terminals.
Begin removing the Speed Switch by first documenting the wires that are connected to its terminals. If necessary, place a piece of masking tape on each wire, noting the terminal number that it’s connected to. Once all of the wires are removed, the Speed Switch can be removed from the Engine Control Panel by removing the four screws that are securing it to the panel. Each screw is fastened to the back of the Control Panel. In order to access the four retaining nuts, the Control Panel may have to be loosened from the engine frame to allow clearance for a wrench. Drawing No. 9777, Section 7, Rev. 02-07