Page 10-8 Section 10 – Maintenance Specifications CFP83 Series Coolant Recommendations and Specifications General Information Heavy-duty diesel engines require a balanced coolant mixture of water and antifreeze. Drain and replace the mixture every 1 year or 1500 hours of operation (whichever occurs first) to eliminate buildup of harmful chemicals. Antifreeze is essential in any climate. It broadens the operating temperature range by lowering the coolant freezing point and by raising its boiling point. Do not use more than 50-percent antifreeze in the mixture unless additional freeze protection is required. Never use more than 68-percent antifreeze under any condition.
Use soft water in the coolant mixture. Contaminants in hard water neutralize the corrosion inhibitor components. Water must not exceed 300-ppm hardness or contain more than 100 ppm of either chloride or sulfate. Specifications Refer to Service Literature in Section 8 for reference to related Cummins service bulletins. Use low-silicate antifreeze that meets ASTM4985 test (GM6038M spec.) criteria. Concentration Antifreeze must be used in any climate for both freeze and boiling point protection. Cummins recommends a 50- percent concentration level (40-percent to 60-percent range) of ethylene glycol or propylene glycol in most climates.
Antifreeze at 68-percent concentration provides the maximum freeze protection and must never be exceeded under any condition. Antifreeze protection decreases above 68 percent. Ethylene Glycol Propylene Glycol 40% = -23°C [-10°F] 40% = -21°C [-6°F] 50% = -37°C [-34°F] 50% = -33°C [-27°F] 60% = -54°C [-65°F] 60% = -49°C [-56°F] 68% = -71°C [-90°F] 68% = -63°C [-82°F] Concentration Testing Antifreeze concentration must be checked using a refractometer (such as Fleetguard® Part No. CC2800). “Floating ball” types of density testers or hydrometers are not accurate enough for use with heavy-duty diesel cooling systems. Drawing No. 9777, Section 10, Rev. 02-07