Section 10 – Maintenance Specifications Page 10-7 CFP83 Series Lubricating Oil Recommendations and Specifications Oil Performance Recommendations Using quality engine lubricating oils, along with appropriate oil drain and filter change intervals, is a critical factor in maintaining engine performance and durability. Refer to Service Literature in Section 8 for reference to related Cummins service bulletins. Cummins Engine Company, Inc. recommends the use of a high-quality SAE 15W-40 heavy-duty engine oil (such as Cummins Premium Blue®), which meets the American Petroleum Institute (API) performance classification CH4/SG.
A sulfated ash limit of 1.0 mass percent is suggested for optimum valve and piston deposit and oil consumption control. The sulfated ash must not exceed 1.85 mass percent. New Engine Break-In Oils Do not use special “break-in” lubricating oils for new or rebuilt Cummins engines. Use the same type of oil during the “break-in” as that which is used in normal operation. Recommended Oil Change Intervals The oil change interval for turbocharged engines is every 6 months or 250 hours.
Oil Viscosity Recommendations The use of multiviscosity lubricating oil has been found to improve oil consumption control and improve engine cranking in cold temperatures while maintaining lubrication at high operating temperatures. While 15W-40 oil is recommended for most climates, refer to the accompanying table for oil viscosity recommendations for extreme climates. NOTE : Limited use of low-viscosity oils, such as 10W-30, can be used for easier starting and providing sufficient oil flow at ambient temperatures below -35°C [23°F]. However, continuous use of low viscosity oils can decrease engine life because of wear. Refer to the accompanying chart. Drawing No. 9777, Section 10, Rev.
02-07